Repairing Roof Edge

Force the mold away from the roofing a few inches at a time then lift off the entire piece in one section.

Repairing roof edge.

Small holes or corroded spots in flashing can be easily repaired. Then reshingle sliding metal step flashing behind the fascia board the trim behind the gutter. Once you repair the hole in the roof plywood you need to seal up the seams and recover the roof. It should overlap another piece of ice and water barrier laid below all the way down to the roof edge.

Staple it to the roof decking or nail it with plastic capped roofing nails. If there are repairs to be done on the roof replace worn out tiles and make sure the entire surface is covered. Save yourself some. It was very easy.

Any damaged plywood should be replaced. This should cover the most leak prone areas. Plug pinholes with roofing cement and patch holes up to about 3 4 inch in diameter with a patch from the same material as the flashing. Starting at one corner of the roof wedge a pry bar into the narrow space at the top of the shingle mold the thin wooden strip that sits just below the shingles.

Use a soft brush to wipe away debris particles and dust that build upon the verge as a result of chiseling. Once all the underlayment is applied go back and place. How to fix a roof drip edge installing roof drip edge flashing properly. Change a rotten or damaged fascia board.

You can install a new fascia board in a couple of hours with the right tools to d. Cut out the damaged section with a circular saw. First roughen the area around the hole with a wire brush or sandpaper and then clean it. Ice and water shield there are many brands should be applied all along the bottom edge of the roof.

Obtain clean water and wet the surface using a brush. Cover the seams between the old and new decking with bitumen tape. Place the metal roof drip edge flashing along the gable ends. Lay felt paper onto the roof overlapping the existing paper to get good coverage.

Install roof drip edge along the eaves add underlayment then place drip. Hold onto the old shingle mold if it looks to be in good shape.