Repairing Hardboard Lap Siding

You might notice bulging along the bottom edges a loose layer or soft.

Repairing hardboard lap siding.

If you can see black marks or streaks anywhere on your masonite siding it is a sure sign of being compromised by water. Be sure the top one goes through both boards. Finish the cut with a sharp utility knife. Remove the siding panel that is damage and install a fresh hardboard siding panel.

Use shims to lift the boards so you can easily get at the one you re cutting. Be sure to stagger the joints see photo 1. Promptly repair holes in masonite hardboard to prevent moisture from further permeating the siding and compromising its structural integrity. Immediately fill holes with a flexible all purpose filler such as pre mixed bridging and patching compound following label directions.

Use a 4 foot level to check and then hammer in another nail. Besides painting the siding can also be scrubbed for cleaning purposes. If you re replacing more than one board in a run simply hammer a nail into the top corner to support it and then move half way down the board. Thick so set your blade depth carefully to avoid cutting into other courses.

Remove the deteriorated hardboard siding using a pry bar and chisel being careful not to damage the good siding above it. Holes are a prominent problem with masonite siding. Fortunately you can repair masonite hardboard siding with wood putty. Repairing hardboard siding if water seeps into joints between hardboard panels or penetrates through small holes it will cause the panels to deteriorate.

If needed replace the sheathing behind the siding using 1 2 plywood covered with builder s felt or housewrap. The siding panels nearest to the ground are usually the first to mold. Remove the damaged siding panel using a claw hammer and extract the nails left on the wall from the old panels using tin snips. Check the siding panel for molds holes or any damage.

Make sure to scrub only the compromised area of the siding so that the structure remains unaffected.