Removing Window Tint Glue From Glass

Normally it is advised that ammonia cleaners not be.

Removing window tint glue from glass.

After a few seconds gently apply pulling pressure on the film. The wider the blade the more efficiently it will strip the plastic from the window. Take your solvent of choice nail polish remover lighter fluid acetone or even engine penetrating oil and soak a paper towel in it. Grasp the film where it has already come loose from the glass and spray some of your soapy water mixture behind it.

Find the edge of the glass and run the razor between it. Short video on how to remove window tint and more importantly the glue that s left on your window. Separate the film from the glass around the edges. I had to peel off 10 year old tint that was baked to the glass by the sun.

You need a solvent to cut through all that window tint glue. Soaps and cleaners don t cut through window tint glue they are simply poor window tint adhesive removers. You can remove the left over glue in under 6 minutes. Spray glass cleaner onto the surface of the glass and clean it thoroughly with a paper towel.

Spray the inside of the window with the ammonia based cleaner until it is saturated. Angle the dryer so it hits where the film and window meet slowly peeling as the glue softens. After peeling the sticker off adhesive and glue marks are left behind which can be a struggle to clean especially if the residue is sticky or greasy. The first is heat.

Just click and pay. Use a spray bottle filled with soapy ammonia and spray down the film thoroughly. Tinting film can be removed with a properly sharpened razor blade. To make the process much simpler apply two things to your window before you begin.

To speed up the process apply a film of plastic wrap over the sprayed window to hold in the moisture. Cleaning glue from glass windows is difficult because it can be easy to leave adhesive residue behind. Remember that window tint. Place it one the adhesive residue to allow it to soften.

Step 2 wipe with solvent. Allow it to sit and respray as it dries. Then let it dry fully before proceeding. Hold the hairdryer about two inches from the window and run it on high until the glue melts enough to pry the edge up.

That will start dissolving the glue and loosen its hold on the glass. Using a clean towel rub the adhesive away using your hairdryer to soften it as. Both ammonia and vinegar will dissolve tinted film adhesive although it may take several hours to do so.