Removing A Towel Bar From Tile Wall

Installing a towel bar on a ceramic tile wall is fairly easy.

Removing a towel bar from tile wall.

This is how to remove a towel rack from drywall. Slowly turn the receiver end upwards. Cut your new replacement bar to size. To elminate as much drywall damage as you can i d advise first to cut or score the top layer of sheetrock around the bar as close to the bar as possible.

As with many tasks proper planning and preparation is the key to success. You can just pull off the tape and clean the rest of the tape with paint removal or glue removal. Remove the bar section of the towel rack by pulling one side in if it s a tension bar. Now that you ve got your supplies it s time to go to work by removing the old towel bar.

This way once you remove the bar the drywall and paper layer on top won t be coming off in unexpected ways. Or if the only problem is the towel bar itself it s missing it s broken or it s just plain ugly just replace it with a spring loaded one. The most convenient towel holders hang on the wall but installing these on tile walls presents some unique challenges. If done correctly you will remove two pieces of tile and.

A demonstration of how to tighten up loose towel bars or to remove them for painting or other needs. 2 apply several layers. Continue to unscrew the receiver ends. Remove the old towel bar.

Before you proceed with the install carefully chose a convenient location for the towels to hang. There will not be any damage done to the towel bar or to the tiles. Once the bar pops out remove it. The receiver ends part that holds the bar should be a separate part than the part connected to the wall.

A good sharp utility knife can help you out in this. However with it on the wall you should be careful not to damage the paint. A towel holder is a necessary feature in a bathroom. Replace old towel bars soap dishes corner shelves and other ceramic fixtures on ceramic tile walls without breaking the tile or cutting into the walls.

I easily pulled my bar out on its own since it was too short to begin with but if yours isn t you can remove it by sawing through the middle of it. It s important to sand and sp. This same procedure should work for similar items that are mounted to drywall.